/jp/ - Otaku Culture

>>41344764
a lot of the 3rd party sites have heads for various manufactures, but there are still a few holdouts that refuse to sell them on their own.

thedollchannel and siliconelovers both have good head selection. i actually got my SE one above through siliconelovers.

compatibility depends a lot on the mfg and type of connection. most have gone to a socket neck and peg head so you have some way of adapting most of them(there are some that have peg necks and socket heads). For my Sanhui to SE, the SE uses a standard m16 half thread/ball peg that a lot tend to use since its cheap and well available. Sanhui has a custom fit peg that seems to be around an M14, so slightly too small to just use the M16 as is.

>>41344816
going to make an M16 to the smaller peg adapter. not anything major, was planning to make it out of wood if i coudnt be arsed to get my printer going and found the right dowel size(first attempt was a bit small).