/diy/ - Do It Yourself

>>1752714
wait, you already had a preconfigured slic3r profile?
literally use the defaults on that and see if it really is a cura problem baka.

also send a picture of the z leadscrew and your zsteps.
extrusion isnt the problem if your z screw is squishing your prints, if it's the correct height then reduce extrusion.
also if you post the cura gcode its not that hard for other anons to open the file and see if its some weird config problem, you're not goig to dox yourself if you just post a pastebin of it

print the cube in sli3r if you already have a config