/diy/ - Do It Yourself

>>1752725
>>try adding a custom FFF printer and set it up to match those values.
That is what I did, the only profile I could load was material related, the other stuff I had to manually copy from the .pdf via adding custom FFF.

>>1752725
>>Your problems are probably from poor assembly and some setting not being right somewhere
I did follow the instructions to a t but I will reassemble it anyways tomorrow.
>>Did you set up your extruder for the correct nozzle size and filament?
As in Cura? Pic related are my settings.
>>Flow
I just reduced it from 100% to 80%
I just read in a forum that this printer does not perform well with speed exceeding 45mm/s so I tuned that down from 60mm/s to 40mm/s.
Should I enable Z-hop when retracted?