/diy/ - Do It Yourself

>>494454
Wasn't shown in the original pic, but I did run 2x4s between the rafters to toughen up the roof a bit.

On another note: I'm running 2x4s on a trailer, where typically 2x2s or 2x3s are the industry standard. The roof should be solid enough to hold some solar panels and keep in general shape for a few centuries.

>>426730
>It died in the intersection, and refused to start again for about a minute or two.

>When we got it back from the mechanic the same thing happened though I tried flooring the accelerator this got it on the freeway and the 75 miles home, barely . . .

Did this ever get fixed? I also think I have a better work around for the wheel wells, but I'm looking into a bit more before I decide that EP-200 Epoxy is the uber duct tape...but if it is, I'm using it to seal the seams in the subfloor, and I'm using it to connect the aluminum corner pieces before the elastothermic overcoating. The only other thing I'm looking at right now is putting down some 1/2" 4x8's on the roof, and running two staggered 'beams' between the middle of the roof trusses to strengthen it up when I walk on it, and when I put the solar panels up.

Pic is of the scabbed in 2x4s between the trusses to hold the aluminum edge a bit better.