/diy/ - Do It Yourself

>>1525820
You'll need a hammer drill. Impacts are for delivering rotational impact to knock a nut open, a hammer delivers a thrusting impact, which helps a masonry bit chisel its way through the material. For what sounds like it's going to be a once off job getting a few holes done, any cheap piece of shit will get you over the line.

Also, don't be a faggot, get an RJ45 crimper and some jacks, cut the heads off and feed your cable without the plugs on. Will be much easier to feed it around without a rectangle on the end to get caught on every little edge it encounters and smaller holes will prevent vermin from using your cable run as a freeway through your house. I tend to wrap the end of the cable in electrical/masking tape to form a conical point before I start feeding it as well, again, one less hard edge for your shit to catch on as you feed.