/diy/ - Do It Yourself

>>1165684
>>perfboard without any copper
>How do I get the wires to stick to the pad then?

you dont. you stick in the component, bend the leads a bit so it doesnt fall out. then make a little loop of wire around one lead, solder, repeat for the other leads.
it makes a much neater board, with way less chance of short circuits.

>Any recommendation for a specific perfboard?

i just go the same store i've been going to for 20 years, and choose the least expensive one. if you're an online kinda shopper, i suppose you look for Copperless Perfboard, as seen in pic.