/diy/ - Do It Yourself

Is there any good comprehensive guides on control boards, drivers (SPI vs UART?...) and compatible displays?
I have not been following the progress of that sector for couple of years, and I want to replace dead ramps1.4.
What is good price/performance? I plan to use Marlin, because that's what I used now. But what is opinion on klipper? I also need raspberry pi? Does any board run it natively, without rpi?

>>2011484
That pic is straight from the archives. 5 years ago. Time fly so fast. goddamit

>>1768671
Yes, I do have a printer. But I will not be printing just 20mm cubes. I will print parts, that go over whole bed.
At the moment I am printing 35h print (cca 400g of filament).
Bent bed, can be "fixed" with a glass. But bent or inaccurate extrusion? Replace it with another extrusion (which might also be bent?).
For small parts inaccuracy of alu-extrusion is not so visible, But I am afraid at 300mm (or even 400, 500mm) it will be. But I cannot test it atm, because I don't have that kind of printer yet. Also I plan to use 0.4mm nozzle and 0.2mm layer height, I cannot go much rougher than than that. Printing PLA.
As I said, I am looking for different options if possible.
If not, I am gonna buy what I can get.

>>1768675
I use cut-resistant gloves and a chisel and safety glasses on those extremely troublesome parts. Otherwise just pliers, cutters and such. Small pieces of pla can be found all over my garage.