/diy/ - Do It Yourself

>try to print something
>it's slightly too big in the wrong places and the nozzle knocks the clips off the bed
>start printing series of tests to see how I should configure max depth to compensate
>extruder skipping
>print leveling test
>leveling got fucked up and the nozzle is too close to the bed
>spend a couple hours re-printing leveling tests and making adjustments
>still not exactly right
I'm just going to start over from scratch with the paper sheet method and everything tomorrow. Probably should've done that in the first place.
I've gotta say, I expected a lot more just werking after the initial setup. The configuring process is starting to look more and more like a rabbit hole.