/diy/ - Do It Yourself

>>2758077
I guess I'll ask here while I'm at it, anyone tried printing nylon and have it curl up off the bed every time, and then fixed it?
I've been messing with head height, temps (255-260 for the head as I haven't looked up how to set it to like 270-275 yet, and 55-100 for the bed), and best lick I've had thus far is setting the head as high as it can go at 260, and then running the bed between 60-70.
I have mrisoc installed, and an all metal direct drive sprite, just need to bother figuring out how to increase the head temp limit.
I've also wondered if it's not just the parts being too small to print at 100% infil/all walls. Just haven't tried printing these at 60% or whatever yet.
I've also included a shit of a bunch of the failed prints that kind of show how they keep warping. They're all bottom up apart from the middle one.