[ 3 / biz / cgl / ck / diy / fa / ic / jp / lit / sci / vr / vt ] [ index / top / reports ] [ become a patron ] [ status ]
2023-11: Warosu is now out of extended maintenance.

/diy/ - Do It Yourself

Search:

View post   
>> No.1711827 [View]
File: 1.46 MB, 640x360, 4jaw tailstock.webm [View same] [iqdb] [saucenao] [google]
1711827

>>1702508
waiting on a couple endmills to arrive to finish up an order.

going pretty good I suppose.

>> No.1611930 [View]
File: 1.46 MB, 640x360, 4jaw tailstock.webm [View same] [iqdb] [saucenao] [google]
1611930

>>1611922
which direction is the cross-slide out of square? would it turn a concave or convex shape on the end of a part?

It's supposed to turn a concave part, if it was convex then that's bad.

The ways being low doesn't actually translate to that much change on the part diameter because it's moving the tool at an angle. My P&W ways are the same way and it's still pretty damn accurate.

>> No.1387863 [View]
File: 1.46 MB, 640x360, 4jaw tailstock.webm [View same] [iqdb] [saucenao] [google]
1387863

>>1387862
I made the aluminum spacer you see there to protrude down below the dovetail of the holder to hit the toolpost to hold it up.

>> No.1339659 [View]
File: 1.46 MB, 640x360, 4jaw tailstock.webm [View same] [iqdb] [saucenao] [google]
1339659

>>1339654
Yes.

>> No.1304055 [View]
File: 1.46 MB, 640x360, 4jaw tailstock.webm [View same] [iqdb] [saucenao] [google]
1304055

pic related is autism, I was just trying to take off as little as possible and leave a good surface finish.

>> No.1253993 [View]
File: 1.46 MB, 640x360, 4jaw tailstock.webm [View same] [iqdb] [saucenao] [google]
1253993

>>1253347
Yep, same brand I have to run my old lathe.

>> No.1232643 [View]
File: 1.46 MB, 640x360, 4jaw tailstock.webm [View same] [iqdb] [saucenao] [google]
1232643

>>1232582

Navigation
View posts[+24][+48][+96]