/diy/ - Do It Yourself

>>1746566
Thank you for your reply. I may try 0.16 for the next half, I did this at 0.2. I just had another look at it, and have noticed this section too. This sort of effect with lines on the same layer not joining together tends to occur on the print bed, with the layers not being thick enough to touch each other, but I'm wondering since this is printed on a massive support structure whether that's the case or not as there is no flat uniform surface underneath. So let me try narrow down my question again, is there any name for layer lines not being thick enough to touch each other? I'm planning on covering this with primer and spray painting it so not a dealbreaker now, but for future sake it'd be interesting to see if there's a solution for this.