/diy/ - Do It Yourself

Well I was going to buy a Bulldog Lite clone, but the chinese fucked them up.

The tensioner is supposed to have two through holes (the size of the springs) where the springs go through, then two set screws to set the tension.

Instead they just tapped and put 3mm bolts in.
So there is no adjustable tension at all, and everyone says "1 spring is enough" because 2 will eat and destroy filament, not realizing the design is fucking flawed.

And of course there is a plastic version of it that actually implemented it right.
So annoying because its such a good design.