[ 3 / biz / cgl / ck / diy / fa / ic / jp / lit / sci / vr / vt ] [ index / top / reports ] [ become a patron ] [ status ]
2023-11: Warosu is now out of extended maintenance.

/ck/ - Food & Cooking

Search:


View post   

>> No.8226441 [View]
File: 88 KB, 516x624, SCAA_brew_chart.jpg [View same] [iqdb] [saucenao] [google]
8226441

for repeatable results you will need:
-a digital scale (~10 bucks amazon)
-a digital thermometer (~5 bucks amazon)
-a 6 cup chemex (paper or cloth filter will do. metal filters work as well, but they leave sediment)
-ideally a pouring kettle (with a flow restrictor even better), but a measuring cup with a spout can certainly do the trick
-a burr grinder
-your coffee of choice
for a 6 cups chemex, i like to use 45 grams of coffee and 750 ml 9grams) of water.
what i do is either weigh out 750 grams of water or fill a measuring cup to 750 ml. toss that into a kettle, bring to a boil.

i rinse my paper filter while its in the chemex under hot water (i use the spray attachment on my sink) and keep the hot water in the chemex until i'm ready to brew.
grind your coffee (for a chemex i aim a little finer than a flat bottom drip setting, your grinder's particle size will vary).
pour your boiling water into your pouring vessel, this usually brings the temp down a bit to where i want it to be. i aim for 202-200F. if its too hot, you can just stir the water around until it gets closer to a proper brewing temperature.

because youve already weighed/measured out your water, theres no need to brew on top of a scale to keep track of your water weight. so use up all of the water in your pouring vessel (minimal water is lost to steam when boiling)
saturate your coffee grounds slowly. this should take about 45 seconds.
once the first drips start to hit the bottom, your coffee bed is saturated and you can start your pour.

pour in a spiral going outwards from the middle, but don't touch the edge of the filter. sprial back in and out. keep the water level about an inch from the top. this stage here should take about 4 minutes, so dont pour too fast.
if your water drained out too fast, make your grind finer. too slow, make grind coarser. i've used this method with a TDS meter and hit ~20% extraction yields consistently.

>> No.5585817 [View]
File: 88 KB, 516x624, SCAA_brew_chart.jpg [View same] [iqdb] [saucenao] [google]
5585817

>>5585666

There's a sweet spot for extraction. Adding too much coffee just makes for a bitter cup.

Navigation
View posts[+24][+48][+96]